|
|
|
 |
|
|
|
|
|
Hp laserjet 1020 Software
The HP 1020 LaserJet smoothly process documents containing text, images, and graphics with its speedy 234MHz processor and ample 2 MB of memory. Jobs will print out at a quick 15 pages per minute, and thanks to HP's Instant-on technology
HP laser jet Printer 1020
|
 |
|
|
|
|
Hp laserjet 1020 Software
HP laserjet 1020 Printer Digital Imaging Products - Software Installation Stops at 96%
Hp laserjet 1020 Software Issue
While installing the product software on a computer, the Install window locks up (stalls) and stops with 96% of the software installation complete. The Install window eventually disappears. When this happens, the Scan function does not work from HP Solution Center or HP Director. It may also cause only two icons to be displayed in the HP Director or Solution Center. When this happens, the Digital Imaging Monitor does not run in the Task Bar.
NOTE: Verify the hardware functionality of the device by making a copy (all-in-one devices) or printing a self test page. Refer to the product documentation or the user guide to accomplish this.
Solution for Hp laserjet 1020 Software
Listed below are several possible solutions to this issue. Start with the first solution, and if that does not resolve the issue, proceed to the next solution. You might not need to try every solution.
Solution one: Reboot the computer
Click Start .
Click Shut down and then click Restart to restart the computer.
If there is a message stating that HP Software installation is running , restart the computer by pressing the power button on the computer to turn it off and then back on.
The installation will continue from the 96% and the Web Registration screen will display. If the installation does not continue, proceed to the next solution.
Solution two: Reset the device
While the device is turned on, unplug the power cord and universal serial bus (USB) cable from the back of the device.
Wait 30 seconds.
Plug the power cord back into the device.
Press the On button to turn on the device.
NOTE: For an all-in-one a partial reset may be needed. Click here for instructions to perform a partial reset of the all-in-one (c00060793) (in English).
Connect the USB cable back to the HP device .
Turn the computer on and connect the device to the computer while it is rebooting.
The software installation should then continue from 96% and finish successfully with Congratulations and Web registration screens.
NOTE: The software installation might not continue immediately after the computer is rebooted and you may notice no activity on the screen. Wait a few minutes until the installation screen is re-launched. You should also notice an icon with or without a found new hardware message on the bottom right of the computer screen. This ensures that the installation is in the process of getting launched
|
|
|
|
|
|
|
|
Hp
laserjet 1020 printer setup
Hp
laserjet 1020 specifications
Hp laserjet
1020 cartridge
Hp
laserjet 1020 Service Manual
|
|
|
